Ezlink; Cem; Homologaciones, Certificación Y Seguridad - ABB AWT420 Instrucciones De Funcionamiento

AW T4 2 0 | T R A N S M I S O R U N I V E R S A L D E E N T R A D A I N D I V I D U A L Y D U A L D E 4 H I LO S | C I/A W T4 2 0 - E S R E V. C

EZLink

Consumo de potencia (máximo)
150 mA a 24 V CC (3,75 W máx.)
Cable de longitud fija
1 o 10 m (3,28 o 32,8 pies)
Protección IP del conector del sensor digital
IP67 (cuando está conectado)
Cable de extensión (opciones)
1, 5, 10, 15, 25, 50 m (3,2, 16,4, 32, 49,2, 82, 164 pies)
Longitud máxima (incluido el cable de extensión opcional)
Hasta 210 m (826 pies)

CEM

Emisiones e inmunidad
Cumple los requisitos de la norma IEC61326 para entornos
industriales
Homologaciones, certificación y seguridad
Homologación de seguridad
cULus
Marcado CE
Cumple las directivas EMC y LV
(incluida la última versión de IEC 61010)
Seguridad general
• IEC 61010-1
• Grado de contaminación 2
• Clase de aislamiento 1
Bluetooth
El módulo Bluetooth de bajo consumo del transmisor
AWT420 ha obtenido la aprobación reglamentaria
en los siguientes países:
• Europe/CE
Europe
0197
• Japan/MIC: 005-101150
Japan
Contains transmitter module with certificate number:
005-101150
• Korea/KCC: MSIP-CRM-mcp-BM71BLES1FC2
Korea
MSIP-CRM-mcp-BM71BLES1FC2
• China/SRRC: CMIIT ID: 2016DJ5890
China
CMIIT ID: 2016DJ5890
• United States/FCC ID: A8TBM71S2
U.S.
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
recieved, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
35