Cequent Performance Products 76192 Instrucciones De Instalación página 4

Trim bumper fascia – Measure to find the center of the fascia, mark a centerline on the
bottom of the fascia and trim as shown in Figure 2. Mark a centerline on the vertical
portion of fascia and trim as shown in Figure 3 * Do not trim away the bottom edge.
*Dimensions are approximate and may be adjusted for fit and aesthetics*
Figure 2 Bottom View
Figure 3 Rear View
Leave the bottom edge!
Install hitch – Raise the hitch into position over the exhaust and forward
enough so that the receiver clears the bottom edge of fascia. Align the
holes in the hitch with the vehicle existing weldnuts and install the bolts
removed earlier.
©2017 Horizon Global™ Corp - Printed in Mexico
Lower exhaust and remove existing fasteners – Lower the exhaust by
removing (2) bolts from each rear exhaust hanger bracket (1 per side)
with a 13mm socket. Remove (4) M10x1.5x40mm bolts from the outside
of the frame rails (2 per side) with a 16mm socket.
Torque fasteners - Tighten the M10 fasteners with torque wrench to 53Lb.-
Ft. (72 N*M)
Proper torque is needed to keep the hitch secure to the
vehicle when towing.
Sheet 4 of 15 76192NP 9-8-17 Rev. A