Korona 82100 Manual De Instrucciones página 24

- If the value for the preset relative humidity has been reached in the Auto (12) program, the compressor
switches off and the fan continues to run further. If the value is exceeded, the device switches on again.
- The device switches off when the condensation water tank is full or removed. If the tank is incorrectly
inserted or if the condensation water tank has been removed, the Water full LED (13) flashes and an
acoustic signal sounds when the device is switched on.
- Turn off the appliance by pushing the on / STAND-BY (8) button.
- After use, disconnect the appliance from the mains.
OPERATING MODE AND STATUS DISPLAYS
Humidity level is indicated by the LED indicating bar by 3 different LED light colors:
Blue : Humidity < 45%
Green : 45% ≤ Humidity ≤ 65%
Red : Humidity > 65%
- Error codes E0, E2, cL, cH, LO, HI: Red
The various operating states are shown on the LEDs in the control panel.
Please note the following table:
LED
Power LED (9)
LED continuous mode (10)
LED mode Auto (11)
Timer -LED (12)
Water full LED (13)
Key lock LED (15)
Reset LED (16)
Sleep mode LED (17)
LED, high fan level (18)
LED, low fan speed (19)
SELECT PROGRAM
The device has different programs.
- Press the respective button to set the desired program. The corresponding LED shows the setting.
SPECIFY THE TARGET VALUE FOR AIR HUMIDITY
In the Auto mode you have to set the target value for the desired humidity.
- Press the MODE button until the Auto LED lights up and use the
humidity in 5% steps between 30% and 80%. The set value is shown on the display for approx. 5
seconds.
Continuous mode - laundry drying
Press the MODE button until the continuous mode LED lights up.
This setting enables a very low level of humidity to be reached since there is continuous dehumidification. A
target value for air humidity can therefore not be set.
Note: The minimum air humidity that can be reached in this operating mode depends on factors such as
the room size or the ambient temperature, etc. There is therefore no minimum value that can be achieved.
Fan strength
- Press the SPEED button to choose between high or low fan strength.
Sleep mode
- Press the SLEEP/RESET button to activate the sleep function. The device switches to the quietest and
most energy-saving mode. The corresponding LED lights up.
- Press the SLEEP/RESET button again to deactivate the function. The corresponding LED turns out.
24
Meaning
Device is connected to the mains
Device operates in continuous mode, i.e. permanent
A value for air humidity is preset: if it is reached the compressor
switches off, if it is exceeded the compressor switches on again.
Timer is activated; if the timer is deactivated, the LED is off
Water tank is full and must be emptied
Key lock is activated
Filter needs to be cleaned. Deactivate the Reset LED by pressand-
hold the SLEEP/RESET button for 3s.
Sleep mode is activated
High fan level
Low fan speed
buttons to set the desired