Problem Solving - Korona 82100 Manual De Instrucciones

PROBLEM SOLVING

Problem
The unit is not operating.
There is little formation
condensate.
Water Leakage
Excessive Noise
Error code
Inspection / cause
check the power connection.
check if the water level indicator
lights up?
check the room temperature.
of check the air filter for dirt.
check if the air duct is blocked.
check if the room temperature
is below 20 °c.
Set humidity level is higher than
current humidity value.
Overflow while moving the unit.
check if the drain hose is kinked
or bends.
check if the unit is securely
positioned.
check if any loose, vibrating
parts.
Noise sounds like water flowing.
E0 connection problem between
main PcB board and display
board.
E2 Humidity sensor dampened or
failure.
cL Display when
temperature is below 5 °c.
cH Display when
temperature is above 38 °c.
LO Display when Room relative
humidity is below 20 %rH.
HI Display when Room relative
humidity is above 90 %rH.
Instruction Manual
Solution
Insert the power plug securely
into the wall outlet.
Empty the water tank and
reinstall correctly.
The range of
temperature is 5-38 °c.
clean the air filter as necessary.
To clear the obstacle.
This is normal. Low humidity in
low temperature environment.
Set the humidity level below
current humidity value.
Empty the water tank before
transport.
Straighten the hose to avoid a
trap existing.
Place the unit on horizontal and
firm ground.
Secure and tight the parts.
Noise comes from
refrigerant. This is normal.
check the connection wire
between them.
clean or replace the humidity
sensor.
Room Normal. The compressor stops,
and the fan keeps running.
Room Normal. The compressor stops,
and the fan keeps running.
Normal. The compressor stops,
and the fan keeps running.
Normal. The compressor and
the fan keep running.
ENGLISH
operating
flowing
27