Timer function
The device is equipped with a timer that can be activated in any operating mode and in standby mode.
Times from 1-24 hours can be selected in 1-hour steps. After the set time has elapsed, the device is
switched on or switched to standby.
-
Press the TIMER button during operation mode or in standby. The timer LED lights up and the time
flashes in the display.
-
Press the
buttons to set an on or off time from 1 to 24 hours. The selected time flashes on
the display for approx. 5 seconds.
-
To end the timer before, press the TIMER button and then press the
appears on the display. The timer is now deactivated and after toggling the display the timer LED turns
off.
Parental controls
The device is equipped with a child lock to prevent children from accidentally switching the device on or
off or changing settings. When the childproof lock is activated, all buttons on the device have no function.
-
Press the LOCK button for approx. 3 seconds. A signal tone sounds and the corresponding LED lights
up. The child lock is now activated.
-
Press the LOCK button again for approx. 3 seconds to deactivate the childproof lock. A signal tone
sounds and the LED turns off.
CLEANING AND CARE
Clean the appliance and filters regularly to maximize performance and efficiency, and to prolong the
appliance's life.
Before cleaning, always switch off the appliance and disconnect it from the mains. Never
immerse the appliance in water. Danger! Electric Shock!
-
clean the appliance using a soft damp cloth.
Never use alcohol, gasoline, and/or any other aggressive cleaning agents/hard objects that may
damage the appliance exterior. Never spray water directly onto the unit.
To remove dust between the vents, use a soft brush or carefully use the vacuum cleaner.
EMPTYING THE WATER TANK
The device has an internal water collection tank. Once, the capacity of water tank is reached, the
appliance stops operating and the water tank LED on the control panel lights up.
In order to empty the water tank, turn off the appliance and disconnect it from the mains.
-
Place the appliance device on an elevation, and place a bucket or any other kind of container underneath
the drainage.
ATTENTION:
• Keep the appliance upright and carefully move the appliance to avoid water spillage over the brim of the
water collection tank.
-
If the capacity of the used bucket is not enough to collect all the water, reattach the lid to the drainage
hole, empty the bucket and repeat the steps until the water tank is completely empty.
Instruction Manual
buttons until 00
ENGLISH
25