Maintenance; General Instructions; Refrigerant; Preventive Maintenance Programme - Parker PSE Serie Manual De Uso

7 Maintenance

a) The machine is designed and built to guarantee continuous opera-
tion; however, the life of its components depends on the mainte-
nance performed.
b) When requesting assistance or spare parts,identify the machine's
model number and serial number (located on the unit's serial label)
and provide to Parker or an authorized Parker distributor.
c) Circuits containing 5t < xx < 50t of CO2 should be checked annu-
ally to identify any potential leaks.
Per European Regulation EU No. 517/2014 art. 4.3.a, 4.3.b) - Circuits
containing 50t < xx < 50t of CO2 should be checked for leaks every
6 months.
d) Per European Regulation EU No. 517/2014 art. 6 - Machines con-
taining 5t CO2 or more, the operator must keep a written record of
the quantity and type of refrigerant used, added or recovered during
maintenance/repair and fi nal disposal.

7.1 General instructions

!
Before any maintenance, make sure:
• the pneumatic circuit is no longer pressurized;
• the dryer is disconnected from the main power supply
Y
In the event of refrigerant leakage, contact qualifi ed and authorized
personnel.
Y
The Schrader valve must only be used in case of machine malfunc-
tion: otherwise any damage caused by incorrect refrigerant charging will
not be covered by the warranty.

7.2 Refrigerant.

Charging: any damage caused by incorrect refrigerant replacement car-
ried out by unauthorized personnel will not be covered by the warranty.
Z
Y
The equipment contains fl uorinated greenhouse gases.
At normal temperature and pressure, the R513A refrigerant is a colorless
gas classifi ed in SAFETY GROUP A1 - EN378 (group 2 fl uid according to
Directive PED 2014/68/EU)
GWP (Global Warming Potential) = 573.
!
In the event of a refrigerant leakage, ventilate the room.
English

7.3 Preventive Maintenance Programme

To maximize the machines effi ciency, reliability and longevity follow the
preventative maintenance guide below:
Maintenance
Activity Description (standard operating condi-
Activity
Check Service
Check POWER ON indicator is lit.
Check control panel indicators.
Check condensate drain.
Clean condenser fi ns.
Verify that the crankcase heater is
correctly positioned
Check electrical absorption.
Check refrigerant leaks.
Depressurize the dryer. Complete
drain maintenance.
Depressurize the dryer. Replace pre-
and post-fi lter elements.
Check temperature sensors.
Replace if necessary.
Dryer maintenance kit.
The following are available (see par. 9.4):
a) 3 years preventive maintenance kits;
b) service kit for
• compressor;
• fan;
• hot gas valve;
• water condenser;
c) individual spare parts.
PSE 325-1000 60Hz

7.4 Dismantling

The refrigerant and the lubricating oil contained in the circuit must be
recovered in conformity with current local environmental regulations.
The refrigerant fl uid is recovered before fi nal scrapping of the equipment
Maintenance Interval
((EU) No. 517/2014 art.8).
tions)
structural work
exchanger
pipes/headers
drain
exchanger insulation
pipe insulation
compressor
condenser
refrigerant
valves
electrical cables
Z
%
Recycling Disposal
steel/epoxy-polyester resins
aluminium
copper/aluminium/carbon steel
polyamide
EPS (sintered polystyrene)
synthetic rubber
steel/copper/aluminium/oil
copper/aluminium
R513A
brass
copper/PVC
11/12