Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4.
Align the hook on the back of the mirror (A) with the
receiving bracket on the main body (B). Carefully lower
the hook into the receiving bracket.
WARNING: Make sure it feels fully seated and secure
before releasing the mirror (A).
5.
Install the screws (DD) on bottom sides as shown.
Hardware Used
DD
Screw
OPERATING INSTRUCTIONS
Touch Switch
(CONT'D)
x 1
DD
Back Light
•
The touch switch on the front of the mirror is to turn the
back light ON/OFF.
•
When the back light is powered ON the button color will
glow Blue; when it is in standby mode it will glow Red.
Adjust Brightness of the Back Light
•
When the back light is powered ON, press and hold the
power button for approximately 3 seconds. The
brightness will scroll up then back down. Take your
finger off the touch button to leave the brightness at the
setting you choose. This brightness setting will be
retained in memory. To adjust the brightness repeat the
above steps.
7
4
A
5
A
B
Publicidad
Tabla de contenido
