Mold Alert - Technoline WS 9420 Manual De Instrucciones

TO USE THE HUMIDITY ALARM
1. To set the humidity alarm, press and hold SET, both
LCD, the humidity digits flash. Press
increment.
2. Press SET once, both
Press or
3. Press SET once or wait for around 10 seconds to return to normal display condition.
4. To turn on the humidity alarm, press ON.OFF once.
5. When air humidity exceeds the set limit, both the
6. Press any key to stop the alarm and flashing LED.
7. To turn off the humidity alarm, press ON.OFF once.
disappears on the LCD.
Remark: Alarm and flashing LED duration 1 minute

MOLD ALERT

1. To select the mold alert humidity, press and hold the
appears on the upper LCD and humidity digits flash, press
humidity value at 60%, 65%, 70%, 75%.
2. Press and hold
condition.
3. If air humidity exceeds the mold alert humidity value, there is a risk of mould formation. The
4. Press and key to stop the LED from flashing,
LCD until the measured air humidity is lower than the preset mold alert value.
Default mold alert humidity: 65%
TO READ DEGREE C/F TEMPERATURE READOUT
Simply press °C/ °F to select degree C or F readout.
and
to set the lower humidity limit in every 5% increment.
/ °C/ °F or wait for around 10 seconds to return to normal display
will appear on the LCD, the red LED will flash every 5 seconds.
or to set the upper humidity limit in every 5%
appears at lower LCD, the humidity digits flash.
or will flash with with flashing LED.
or
/ °C/ °F .
and appears at lower
appears on the LCD.
remains flashing on the LCD.
and the or
or to select mold alert
remains on the
English Page 4 of 6