Festo DSMI-B Serie Instrucciones De Utilizacion página 38

DSMI-...-B
1. Remove the cover cap from the housing (if present).
2. Unscrew the locking nut (K) from the
adjustment sleeve or the shock absorber.
The unscrewing length aD and aE of the
adjustment sleeve or of the shock
absorber (elastomer shock absorber or
shock absorber) can be used to
compensate the deviation of the end
position.
3. Screw the adjustment sleeve or shock
absorber into or out of the shock absorber
retainer using a hexagon spanner.
The permissible unscrewing lengths are
listed in the following table.
DSMI-...-B
Unscrewing length aD
(adjustment sleeve/elastomer shock ab-
sorber)
Unscrewing length aE
(shock absorber)
Fig. 26
When all adjustment sleeves or shock absorbers have been adjusted:
4. Retighten the locking nuts (K) of the adjustment sleeves or shock absorbers.
DSMI-...-B
Tightening torque: adjustment sleeve
1)
Please refer to the operating instructions for the shock absorber for the tightening
torques.
Fig. 27
5. Press the cover cap (if present) of the
DSMI back on to the snap ring.
6. Repeat the test run.
38
Fig. 25
25
[mm] 0 ... 4
[mm] 0 ... 2
25
1)
[Nm] 3
Fig. 28
aD
(K)
aE
(K)
40 63
0 ... 5.4 0 ... 6.6
0 ... 2.7 0 ... 3.3
40 63
20 35
Festo DSMI-...-B 1210b English