Sauder 410412 Manual De Instrucciones página 9

Step 5
Turn four BLACK 9/16" FLAT HEAD SCREWS (BB) into the ENDS (A and B)
å
until the shoulder of the SCREWS rest on the surface of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (N) onto the ENDS (A and B). Line up the groove
å
in the MOLDINGS over the head of the SCREWS in the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS, remove them and
å
slide them on again.
Shoulder
www.sauder.com/services
Apply pressure with your hands as you
guide the MOLDINGS onto the ENDS.
N
B
N
410412
A
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
BB
Page 9