Kenmore 405.84126 Manual De Uso página 14

O TEMP SENSORfeature
NOTE:This feature can be activated from the remote control ONLY. The remote control
servesas a remote thermostat allowing for precise temperature control at its location.
To activate the TEMP SENSOR feature, point the remote control towards the unit and
press the TEMPSENSOR button. The remote display shows the actual temperature at it's
location. The remote control will send this signal to the Air Conditioner at intervals of
every 3 minutes until pressing the TEMP SENSOR button again.
if the unit does not receive the TEMP SENSOR signal during any 7 minute interval, the
unit will beep to indicatethe TEMPSENSORmode has ended.
ACCESSORIES
PART PART NAME QUANTITY
Exhaust hose and Adaptor I 1 set
_(_ __ (narrow mouth)and Adaptor B
(round mouth), Window Slider
and Screw
Foam SeaLs: 2 Adhesive, 3pc
1 Non-adhesive
Remote Control and Battery 1pc
Drain hose and drain hose adaptor 1pc
ERROR CODES AND PROTECTION CODE:
El- Room temperature sensor error - Unplug the unff and plug ff back in. If error repeats, arrange
for service.
E2- Evaporator temperature sensor error - Unplug the unit and plug it back in. if error repeats,
arrange for service.
E3- Condenser temperature sensor error - Unplug the unit and plug it back in. If error repeats,
arrange for service.
E4- Display panel communication error - Unplug the unit and plug it back in. if error repeats,
arrange for service.
P1- Bottom tray is full - Connect the drain hose and drain the collected water away.
If error repeats, arrange for service.
OPERATING INSTRUCTIONS
COOL operation
1. Press the "MODE" buffon until the "COOL" indicator light comes on.
2. Press the "+" or "-" buffons to select your desired room temperature.
The temperature can be set within a range of 62°E (17°C) - 88°E (30°C).
3. Press the "FAN" button to choose the fan speed.
14