Kenmore 405.84126 Manual De Uso página 27

Before calllng for service, review the chart below Nrsf yourself,
PROBLEM
1.Unit does not
Start when
Pressingon/off
Buffon
2. Not cool enough
3. Unit noise or
vibration
4. Gurgling sound
5. Unit stops
operating
6. RESET Button
pops out on LCDI
plug
CAUSE
P1appears in the
display window
When in COOL mode, room
temperature is lower than
the set temperature.
The windows or doors in the
room are not closed.
There are heat sources inside
the room.
Exhaust air hose is not
connected or blocked.
Temperature setting is too high.
Air filter is blocked by dust.
The ground is not level or
not flat enough.
The sound comes from the
flowing of the refrigerant
inside the Air Conditioner.
The automatic over heat
protection function. When
the temperature at the air
outlet exceed 158°E/70°C,
the device will stop.
Temporary power overload
or fault condition
SOLUTION
Drain the water in the
bottom tray.
Resetthe temperature.
Make sure all the windows
and doors are closed.
Remove the heat sources
if possible.
Connect the hose and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on "a" flat,
level ground if possible.
It is normal.
Switch on again after the unit
has cool down.
Press the reset button on the
LCDI plug.
27