Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
@-
@-
@-
@-
@-
®
®
I
o
6 TEMP SENSOR Button
1 ON/OFF
Button ( _/_
)
Turns the main unit on and off
2 MODE
Button
Each time the button is pressed, the operating
mode changes
in this sequence:
FAUTO
_-'_COOL
_-'_DRY
_
FAN "7
3 SLEEP Button
Enables/Disables
the SLEEP function.
NOTE: If the unit is in
SLEEP mode, it will be cancelled
if the MODE,
FAN SPEED or
ON/OFF
buttons are pressed.
4 TURBO Button
Activates
the TURBO function.
The fan will increase
to
maximum
speed, in COOL
mode only. There is no effect
in
other modes.
5 SWING Button
Used to stop or start the horizontal louver auto swing function.
The remote control
serves as a remote thermostat
allowing
for temperature
control
at its
location.
To activate
the TEMP SENSOR feature,
point the remote control
towards
the unit
and press the TEMP SENSOR button.
The remote display
shows the temperature
at its
location.
The remote control
will send this signal to the Air Conditioner
at intervals
of every
3 minutes until the TEMP SENSOR button
is pressed again.
If the unit does not receive the
TEMP SENSOR signal during
any 7 minute interval,
the unit will beep to indicate
the TEMP
SENSOR mode
has ended.
7 RESET Button
If the recessed RESET button
is pressed, all current settings are cancelled
and the control
will return to the initial
settings.
8 UP Button ( "_/-k
)
Push this button
to increase
the setting temperature
or to increase
the hour during
Timer
setting.
9 DOWN
Button ( v/m
)
Push this button
to decrease
the setting temperature
or to decrease
the hour during
Timer
setting.
10 ONE TOUCH
Button
* Used to restore to a favorite
setting or the previous
settings.
The first time the unit is connected
to power,
if the ONE TOUCH
button is pressed, the
unit will change
to AUTO
mode, set to 76°F, and the fan speed will be set to Auto.
If this button is pushed when remote controller
is on, the system will automatically
revert
back to the previous settings including
operating
mode, setting
temperature,
fan speed
level and sleep feature
(if activated),
and it will transmit
these settings to the unit to set it.
If this button is pushed when remote controller
is off, the system will automatically
revert
back to the previous settings including
operating
mode, setting
temperature,
fan speed
level, but will disable
the Sleep feature.
The remote will not transmit
the signals to the unit.
19
Publicidad
Tabla de contenido
