Publicidad
Idiomas disponibles
Idiomas disponibles
Begin aligning the straps. The large strap is used for the
8
hinge side. Align the top and bottom holes and top edge
of the large strap to the two holes on the C-bracket.
Pre-drill with a
3
3
3
screws. Repeat step for each corner (Fig. 9).
Align, mark and pre-drill the 3 remaining holes on the
9
large strap with a
the rail and through the inserted C-bracket from step 5.
Secure with three #8 x
each corner (Fig. 10)
Flip over the panel, align and attach the small straps
10
with one #8 x
attached (Fig. 11).
Using the 4 holes as a guide, pre-drill and install four
11
#10 x
⁄
⁄ " screws to mount the straps to the back of the
⁄
⁄
3
3
3
4
4
upright, being sure to overlap the straps (except for the
locations where hinges will be installed. These screws will be
added later). Repeat this step for each corner (Fig. 12).
⁄
⁄ " bit then secure with 2 of the #8 x
⁄
⁄
32
32
⁄
⁄
⁄
⁄ " drill bit. Be sure to go through
3
3
3
32
32
⁄
⁄ " screws. Repeat this step for
⁄
⁄
3
3
3
4
4
⁄
⁄
⁄
⁄ " screw. Repeat until all small straps are
3
3
3
4
4
Large Strap
⁄
⁄ "
⁄
⁄
3
3
3
4
4
Fig. 9
C-bracket
Fig. 10
Fig. 11
Small Strap
Fig. 12
5
Publicidad
