Barrette Xpanse BOM-34107756 Instrucciones De Instalación página 8

Install Latch:
15
a. Hold latch against the side of the post and mark
locations of pilot holes, as shown (Fig. 20).
b. Drill four ⁄ ⁄ ⁄ ⁄ " pilot holes into the post.
3 3 3
c. Place four 1" screws through the
screw holes on the larger, side-surface of
the post plate (Fig. 21).
d. Place the four spacers onto the screws (on
the opposite side of the post plate), so they
will be between the post plate and the post
when post plate is mounted (Fig. 20).
e. Secure latch to side of Post with four
1" Phillips screws (Fig. 22).
Install Striker Bar:
16
a. Close the gate and insert striker bar into latch, while
holding it rmly against the gate.
b. Mark pilot holes through the screw holes (Fig. 23).
c. Remove striker bar and drill
d. Place striker bar on gate and secure with six
1" Phillips screws
NOTE:
A padlock can be placed through the holes at the top
of the latch for added security.
8
32 32
⁄ " pilot holes. ⁄ ⁄ ⁄
3 3 3
32 32
Fig. 20
Latch Latch
Post Post
Fig. 21
Post Plate
Fig. 22
Fig. 23