Craftsman 316.292601 Manual De Operación página 7

USING THE CORD RETAINER
There is an extension cord retainer to prevent the extension
cord from disconnecting during use. The retainer hangs from
the cord guide bar.
NOTE: Do not plug the extension cord into the power source
receptacle until the cord is connected to the cord
retainer and plugged into the unit.
To use the cord retainer:
1. Fold the extension cord in half, forming a tight loop near
the receptacle.
2. Push the loop through the bottom hole in the retainer (Fig. 3).
3. Slide the loop over the retaining clip and pull down until the
cord fits snugly (Fig. 4).
ASSEMBLY INSTRUCTIONS
Fig. 3
Fig. 4
NOTE: Use a UL-approved extension cord. A 100-foot, 14-
gauge cord is recommended. A 50-foot, 16-gauge
cord is acceptable.
The cord retainer keeps the extension cord safely to the side of
the operator by sliding to the left and right on the guide bar as
the unit is moved. Connect your extension cord to the unit as
shown in Figure 5.
Fig. 5
7