Cleaning; Cleaning The Blender - Silvercrest SSM 600 B2 Instrucciones De Uso

Cleaning

RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket .
Do not immerse the motor block 6 in water or other liquids . This could
result in you receiving a fatal electric shock and cause damage to the
appliance .
► Never open the housing of the appliance . Otherwise, there is a risk of a
fatal electric shock .
WARNING! RISK OF INJURY!
► Never disassemble the cutting blades 4 and never reach into the blender 3 .
The cutting blades 4 are extremely sharp!
CAUTION – PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them .

Cleaning the blender

■ To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
with a long-handled washing-up brush .
■ Clean the measuring cap 1 and the lid 2 in mild soap solution . Ensure that
the rubber seal 9 is correctly fitted before using the lid 2 again .
NOTE
■ If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender 3 with 750 ml of water and add a few drops of mild
detergent . Close the lid 2 and fit the blender 3 onto the motor block 6 .
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades 4 churn through the water
at full speed .
Afterwards, rinse out the blender 3 with lots of clean water to ensure that
all detergent residues have been removed .
SSM 600 B2
You can also clean the lid 2, the measuring cap 1 and the blender
3 with the cutting blade 4 in your dishwasher .
GB │ MT │ 67 ■