Fanimation DUPLEX FPD6254GR Manual Del Propietário página 15

How to Operate Your Ceiling Fan (continued)
6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch
that controls the power supply is moved to the on
position, press and hold the "SET" button inside of the
battery compartment of the handheld remote control for
1-5 seconds.
2) You must press the "SET" button within 60 seconds
of restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the
handheld remote control before pressing the "SET"
button, otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the "SET" button, please turn
the wall switch that controls the power to the fan to the
o position then on again, and start the process
beginning with Step 1 above.
5) When you press the "SET" button, the light will turn
on and o twice, and it has finished the control set up
process.
6) The fan is now ready for normal use.
7. Functions of your remote buttons: (Figure 5)
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
: Turns the fan off.
: Controls fan direction - forward and reverse.
: Controls light-Infinite light levels are available by
holding the light on/off button.
8. "D" and "ON" dip switch:
For this fan, switch should be in the "ON" position, allowing
for dimming of the light. (Figure 6)
The receiver provides the following protective function:
Lock position: The DC motor has a built-in safety feature
against blade obstruction during operation. If something
obstructs the fan blades the motor will stop operating after
30 seconds of interruption. Please remove obstacles and
reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shutdown and fan operation will cease.
Disconnect the power supply and after 5 seconds return-
power on to the fan. (Figure 6)
II = low speed
IV = medium speed
VI = high speed
NOTE: If you want to change the blades: turn
power off change the blades
15
Figure 4
Figure 5
Figure 6