Garden Treasures VA68098 Manual Del Usuario página 11

INSTALLATION INSTRUCTIONS
3. To install the arbor into the ground with concrete
footings, complete step 2 with 6 in. wide x 18 in. deep
holes. Fill holes with wet cement within 3 in. of your
grade (you will need 2 bags of pre-mix concrete -
purchased separately). Carefully move the arbor back
into position.
Support the arbor plumb and level over the holes with
bricks, stones or blocks of wood under the bottom rail
of the side panel. The post bottoms should insert them-
selves approximately 1/2 in. into the concrete.
4. Optional.
If you plan on attaching a fence or bench to the arbor,
or in the event of extreme wind conditions, we would
not recommend using the ground anchors provided.
Consider purchasing pressure treated lumber and trim-
ming it down to 3 1/4 in. wide and cutting it into 36 in.
lengths.
Insert into the bottom of all four posts until they hit the
bottom horizontal rail on the side panel. Fasten with
screws and install either directly into the ground or into
a concrete footing (recommended).
3
18 in
6 in.
4
11
G