Adjustments; Bevel Stop Adjustment - KNOVA KN M-2509RC Manual Del Usuario

ADJUSTMENTS

BEVEL STOP ADJUSTMENT

WARNING
To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
90° (0°) Bevel Adjustment (Fig. O)
1. Loosen bevel locking handle (1) and tilt the cutting arm
completely to the right. Tighten the bevel locking
handle (1).
2. Place a combination square (2) on the miter table (3)
with the ruler against the table and heel of the square
against the saw blade.
3. If the blade is not 90° square with the miter table, loosen
the bevel locking handle (1), tilt the cutting head to the
left, loosen the jamb nut (4) and turn the bevel angle
adjustment bolt (5) in or out with a 10 mm wrench until
the blade is square with the table. Once alignment is
achieved, tighten the lock nut (4) to secure the bolt (5).
4. Tighten the bevel locking handle (1) after alignment
is achieved.
5
1
90° Bevel Pointer Adjustment (Fig. P)
1. When the blade is exactly 90° (0°) to the table, loosen
the bevel indicator screw (1) using a Phillips screwdriver.
2. Adjust bevel indicator (2) to the "0" mark on the bevel
scale and retighten the screw.
2
1
4
2
45° Bevel Stop Adjustment (Fig. P, Q)
1. Set the miter angle to zero degrees. Fully extend the
sliding fence completely to the left then pull the bevel
detent pin (3) toward the front of the machine. (Fig. P)
NOTE: When retracting the bevel detent pin, it may be
required to shift the miter saw upper arm assembly to the left.
2. Loosen the bevel locking handle (4) and tilt the cutting
arm completely to the left. (Fig. Q)
3. Using a combination square, check to see if the blade
is 45° to the table.
4. If the blade is not at 45° to the miter table, tilt the cutting
arm to zero degree, loosen the lock nut (5) and turn the
bolt (6) in or out accordingly.
5. Tilt the cutting arm back to the left and recheck alignment.
6. Repeat above steps until the blade is 45° to the table.
Once alignment is achieved, tighten the lock nut (5)
to secure the bolt (6).
7
Fig. O
5
6
View from rear of machine
9
33.9° Bevel Adjustment (Fig. P, Q)
1. Set the miter angle to zero degree. Fully extend the left
sliding fence.
2. Loosen the bevel locking handle (4 - Fig. Q) and tilt cutting
arm to the 33.9° left bevel positive stop by pushing in on
the bevel detent pin (3 - Fig. P) toward the rear of the
machine.
3. Using a combination square, check to see if the blade is
33.9° to the table.
4. To adjust, turn the screw (7) in or out with a wrench until
the blade is 33.9° to the table.
MITER SCALE (FIG. R)
3
The sliding compound miter saw scale can be easily read,
showing miter angles from 0° to 50° to the left, and 0° to 50°
to the right. The miter saw table has positive stops at most
common angle settings at 0°, 15°, 22.5°, 31.6°, and 45°. These
positive stops position the blade at the desired angle quickly
and accurately. Follow the process below for quickest and
most accurate adjustments.
Fig. P
13
4
Fig. Q