Operation - KNOVA KN M-2509RC Manual Del Usuario

ADJUSTMENTS
EXTENSION WING USE AND ADJUSTMENT (FIG. AA)
The left and right side extension wings can offer extra support
for long workpieces.
1. Lift up on the locking lever (1) and pull out the left extension
wing to the desired support length. Push down on the locking
lever (1) to tighten the extension wing. Repeat for the right
side extension wing if needed.
2. If the locking lever (1) will not tighten, adjust the nut (2), located under
the base, 1/4 turn clockwise using a 10 mm wrench until tight.
REPETITIVE CUTTING USING THE STOP PLATE (FIG. AA)
The stop plate is designed for making repetitive cuts of the same length.
NOTE: Use only one stop plate at a time, NEVER use both stop plates.
1. Rotate the stop plate (3) to vertical position.
2. If stop plate will not rotate, loosen the locking screw (4) 1/4 turn using
a screwdriver and 8 mm wrench.

OPERATION

SAFETY INSTRUCTIONS FOR BASIC SAW OPERATION
BEFORE USING THE MITER SAW
WARNING
To avoid mistakes that could cause
serious, permanent injury, do not plug the tool
in until the following steps are completed:
• Completely assemble and adjust the saw, following
the instructions.
(ASSEMBLY & ADJUSTMENTS)
• Learn the use and function of the ON/OFF trigger switch,
on/off switch for laser, upper and lower blade guards,
head hold-down latch, bevel lock handle, and cover plate
screw.
• Review and understand all safety instructions and
operating procedures in this Operator's Manual.
(SAFETY & OPERATION)
• Review the MAINTENANCE and TROUBLESHOOTING
GUIDE for your miter saw.
• To avoid injury or possible death from electrical shock:
Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging your miter saw.
(ELECTRICAL EQUIREMENTS AND SAFETY)
BEFORE EACH USE INSPECT YOUR SAW.
• Disconnect the miter saw.
To avoid injury from accidental starting, unplug the saw
before any adjustments, including set-up and blade
changes.
• Compare the direction of rotation arrow on the guard to
the direction arrow on the blade. The blade teeth should
always point downward at the front of the saw.
• Tighten the arbor bolt.
• Tighten the cover plate screw.
• Check for damaged parts.
Check for:
• Alignment of moving parts
• Damaged electric cords
• Binding of moving parts
• Mounting holes
• Function of arm return spring and lower guard: Push the
cutting arm all the way down, then let it rise until it stops.
The lower guard should fully close. Follow instructions in
TROUBLESHOOTING GUIDE for adjustment
if necessary.
• Other conditions that may affect the way the miter
saw works.
• Keep all guards in place, in working order and proper
adjustment. If any part of this miter saw is missing, bent,
damaged or broken in any way, or any electrical parts
don't work, turn the saw off and unplug it.
• Replace bent, damaged, missing or defective parts before
using the saw again.
• Maintain tools with care. Keep the miter saw clean for
best and safest performance. Follow instructions for
lubricating. Do not put lubricants on the blade while
it is spinning.
• Remove adjusting wrench from the tool before
turning it on.
• To avoid injury from jams, slips, or thrown pieces,
use only recommended accessories.
• Check the dust bag before you work. Empty the bag
if it is more than half-full.
RECOMMENDED ACCESSORIES
• Consult the ACCESSORIES and ATTACHMENTS section
of this Operator's Manual for recommended accessories.
Follow the instructions that come with the accessory.
The use of improper accessories may cause risk of
injury to persons.
• Choose the correct 10 in. diameter blade for the material
and the type of cutting you plan to do.
17
3
4
1
2
Fig. AA