Electrical Ratings; Troubleshooting; End-Of-Season Care And Storage - Vicks Sweet Dreams VUL575 Serie Manual De Uso Y Cuidado

Weekly Cleaning
Instructions for Disinfecting
Follow Steps 1-3 in Scale Removal Instructions in previous section.
Step 4
4.
Add ½ tsp of bleach to ½ gallon (1.9L) of water and add to Water Tank. Replace
Tank Cap. Swish solution around in Tank. Place Tank on Base. Bleach solution will drain into
Water Reservoir and will disinfect Water Reservoir and other components as they soak.
NOTE: Using more than 1 tsp. of bleach per gallon of water may result in damage to your humidifier.
5.
Allow the bleach solution to remain in Tank and on Base for 15-20 minutes. Unlock Tank Cap
and pour solution out in sink. Pour solution from Water Reservoir out in sink. Wipe Nebulizer
and Float with a soft cloth to remove loosened mineral deposits.
6.
Pour a cup of water into Water Reservoir, lightly swish and pour water out. Do as many times
as needed until smell of bleach solution is gone. Avoid getting water into any openings on the
humidifier base.
NOTE: DO NOT mix vinegar and bleach solutions together. Scale Removal and Disinfecting
must be done separately.

End-Of-Season Care And Storage

Follow the CLEANING instructions when the humidifier will not be used for at least one week, or it is
the end of the season.
At the end of the season, remove any accessories used with the humidifier and allow the humidifier
and accesories to dry completely before storing.
DO NOT store with water inside the Base, Water Reservoir or Tank.
Pack unit safely and store in a cool, dry location.
Consumer Relations
Mail questions or comments to:
Kaz USA, Inc.
Consumer Relations Dept.
250 Turnpike Road, Southborough, MA 01772
TO ORDER REPLACEMENT PARTS CONTACT CONSUMER RELATIONS
Please be sure to specify model number.
Call us toll-free at: 1-800-VAPOR-1-2
E-mail: consumerrelations@kaz.com
Or visit our website at: www.kaz.com

Electrical Ratings

(Continued)
Vicks VUL575 SweetDreams Series Cool Mist Humidifer is rated at 120V, 60 Hz.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR CHECK
YOUR WARRANTY. DO NOT RETURN THE HUMIDIFIER TO THE ORIGINAL PLACE OF PURCHASE. DO
NOT ATTEMPT TO OPEN THE BASE OR TAMPER WITH POWER KNOB YOURSELF, DOING SO MAY
VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.

Troubleshooting

If your humidifier is not working properly, refer to the following:
Problem
Power Knob is turned on
(beyond 'o') and the power
light is off
Power is on and little or
no mist is produced
Water overflows
from Reservoir
Condensation forms around
humidifier or on windows
and walls
Projection Feature
isn't working
NOTE: Failure to keep this unit clean from mineral deposits normally contained in any water supply
will affect the efficiency of operation of this unit. Customer failure to follow these instructions may
void the warranty.
8
Possible Cause Solution
• Unit not plugged in • Plug unit in
• No power at outlet • Check home circuits, fuses;
test outlet
• No water in tank • Fill Water Tank with cool water
• Unit is not level • Place on a level surface
• Clean Nebulizer (refer to
• Mineral deposits on Nebulizer
Weekly Cleaning instructions)
• Power setting may be too low • Turn the Power Knob to
increase output
• Water Tank or Base were • Rinse thoroughly with clean
washed with detergent water until there is no foam or
smell of cleaning solution
• Tank may be damaged
• Check the Tank for any cracks
or damage and replace if
necessary
• Tank Cap is not tight
• Close Tank Cap to lock position
• Tank Cap Seal may be missing
• Check to see if Cap Seal is
attached to Tank Cap. If not,
contact Consumer Relations
• Mist Intensity is set too high • Decrease mist output to
for room size or lower setting or open door
pre-existing humidity level to the room
• Humidifer may be too close
• Move humidifier away from
to wall or window
wall or point Mist Outlet away
from wall or window
• Press Projector Button on top
• Projector Feature isn't
of projector
turned on
• Move Projector Switch directly
• Projector Switch isn't stopped
in front of desired theme's icon
at correct location
until you feel a stop
9