Porter Cable FC350A Instructivo De Operación página 13

Disconnect air line from tool and remove fasteners from magazine
before making adjustments or personal injury may result.
DaIly maIntenance cHart
actIon
Lubricate tool
with 5-7 drops of
PORTER-CABLE
Pneumatic Tool Oil
Drain compressor
tanks and hoses daily
Clean magazine,
magazine release and
contact trip mechanism.
Before each use, check
to insure all screws,
nuts and fasteners are
tight and undamaged.
cleanInG
Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
repaIrS
For assistance with your tool, visit our website at www.deltaportercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
replacement partS
Use only identical replacement parts. For a parts list or to order parts, visit our service
website at www.deltaportercableservicenet.com. You can also order parts from your
nearest PORTER-CABLE Factory Service Center or PORTER-CABLE Authorized
Warranty Service Center. Or, you can call our Customer Care Center at (888) 848-5175.
ServIce anD repaIrS
All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers,
visit our website at www.deltaportercable.com or call our Customer Care Center at (888) 848-
5175. All repairs made by our service centers are fully guaranteed against defective material
and workmanship. We cannot guarantee repairs made or attempted by others.
maIntenance
WhY
Prevents failure
of o-rings
Prevents accumulation
of moisture in
compressor and nailer
Permits smooth
operation of magazine,
reduces wear and
prevents jams.
Prevents jams, leaks
and premature failure
of tool parts.
ServIce
13 - ENG
hOW
Insert drops into air fitting
on end cap of tool
Open petcocks or other
drain valves on compressor
tanks. Allow any accumulated
water to drain from hoses
Blow clean with compressor
air. The use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris.
Tighten loose screws or other
fasteners using the appropriate
hex wrench or screwdriver.