Porter Cable FC350A Instructivo De Operación página 6

Use of this product will expose you to chemicals
known to the State of California to cause cancer, birth defects
and other reproductive harm. Avoid inhaling vapors and dust,
and wash hands after using.
• Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
Use of this tool can generate and/or disburse dust, which may cause seri-
ous and permanent respiratory or other injury. Always use NIOSH/OSHA approved respi-
ratory protection appropriate for the dust exposure. Direct particles away from face and
body. Always operate tool in well-ventilated area and provide for proper dust removal.
Use dust collection system wherever possible.
ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED
SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA respiratory protection.
Before operating this tool, carefully read and understand all instructions in
Important Safety Instructions.
nails
lengths
angle
air Inlet
NOTE: Use only PORTER-CABLE approved fasteners
save these instructions
naIl SpecIfIcatIonS
0.113"–131" (2.87–3.33 mm) diameter, paper
tape collated clipped head framing nails
2"–3-1/2" (50–90 mm)
1/4" NPT (6.4 mm)
6 - ENG
fig. u
FC350A
34º