Cadet The Register Plus RM202 Guia Del Propietario página 3

Installation Instructions
STEP 1
If you are installing a Multi-Watt heater, model numbers RM151 or RM162, begin with
STEP 2 below. If you are installing an RM202, RM208, or RM108, begin with STEP 3 below.
STEP 2
Element Wire Configuration (Multi-watt models RM151 or RM162 only)
Cadet's Multi-Watt RM heater offers a variety of heat output options. You must first determine the desired
wattage and then configure the heating element wire connections. The heater is shipped from the factory
configured for 1600 Watts (240V) or 1200 Watts (208V) for RM162, and 1500 Watts (120V) for RM151. If this is
the wattage you desire, proceed to STEP 3. For 900W/675W/1000W; disconnect the RED Wire BLUE
Terminal "Z" from the lower element spade "C", cut off the BLUE Terminal and tape the end of the wire.
For 700W/525W/500W; follow the directions for the 900W/675W/1000W reduction (See Figure 1), then dis-
connect the YELLOW Terminal "X" from the upper element spade "A" and attach it to the spade "C" where
the BLUE Terminal had been.
On models RM151 and RM162, mark the wiring diagram on the back of the heater with the wattage used for
future reference.
One time
High Temp Cutoff
675W-208V
900W-240V
525W-208V
1000W-120V
700W-240V
500W-120V
Motor End View
Heater Element Locations
STEP 3
Insert Heater
Assembly Into Wall Can
Set the heater assembly (blower
wheel first) into the left side of
the wall can. Fasten at top with
screw provided. Unlace heater
lead wires. Connect the supply
wires to the heater wires (See
Figure 2). Keep all wires away
from element connections when
wires are pushed into free space
on right of heater.
STEP 4
Install Grill
Secure grill with the screws
provided. Turn power on at the
electrical panel board.
Part Two
YELLOW
YELLOW
BLUE
RED
MOTOR
BLACK
Manual Reset
High Temp Cutoff
900W-240V
1600
900
240V
700
675W-208V
1200
208V 675
525
1000W-120V
1500
1000
120V
500
Fasten screw
Blower wheel
Manual reset button
Heater leads
FIGURE 1
L2
WALL
RED
THERMOSTAT
(Not Provided)
L1
700W-240V
525W-208V
500W-120V
FIGURE 2
Supply leads
Grounding pigtail
WARNING
Risk of Electrical
Shock. Connect
grounding lead to
grounding wire
provided. Keep all
foreign objects out
of heater.
WARNING
Risk of Fire.
Heater must be
kept clear of all
obstructions: a
minimum of 3' in
front; 6'' on both
sides and above.
Heaters must be
kept clean of lint,
dirt and debris.
WARNING
Turn the electrical
power off at the
electrical panel
board (circuit
breaker or fuse
box) and lock or
tag the panel board
door to prevent
someone from
turning on power
while you are
working on the
heater. Failure to
do so could result
in serious electri-
cal shock, burns,
or possible death.