Mark GS+ Manual Tecnico página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 123
not allowed.
When the maximum length of the flue systems is exceeded, as shown in table [4], the diameter of
the single flue sets, including extension pipes and elbows, must be increased by one size.
Caution:
- The values shown in the resistance table [4] apply only to the delivered and advised flue systems
supplied by the manufacturer.
- Discharge material with a different resistivity can influence the length of the total supply and
discharge route.
- The Ph-value of condensate is 3.4!
The roof and wall pass-throughs supplied by the manufacturer are identified by the following item
numbers:
Appliance type
G+ 15/25/35/40
G+ 60/80/100
G+ 135/150/200
The extension pipes and bends of the gas flue exhaust system must satisfy the following
requirements:
Appliance type
G+ 15/25/35/40
G+ 60/80/100
G+ 135/150/200
6
Roof pass-through C33
59 90 557
59 90 561
59 90 564
Minimum diameter
80 mm
100 mm
130 mm
Wall pass-through C13
59 90 581
59 90 585
59 90 589

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gc+G+

Tabla de contenido