Switching Off; Automatic Shut-Off; Care, Maintenance And Disposal - Beurer UHP 26 Manual De Instrucciones

The control connector must be connected to the heating pad connector before plugging the unit into an
electrical outlet. After connecting the heating pad connector to the control connector, plug the unit into a
120V AC electrical outlet.
Switching On
Set the controller to 1, 2, 3, 4, 5 or 6 to switch on the heating pad.
NOTICE
• The heat indicator light illuminates after the heating pad is switched on.
• This heating pad features rapid heating, which allows it to heat up within the first 10 minutes of operation.

Switching Off

Set the controller to 0 to switch off the heating pad.
NOTICE
• The heat indicator light will switch off.
Selecting Temperature
Just before using the heating pad, set it to the highest temperature setting (setting 6). This will cause the
heating pad to warm up quickly. When using the heating pad for several hours, set it to the lowest tem-
perature setting (setting 1).

Automatic shut-off

The heating pad switches itself off automatically after about 120 minutes. The heat indicator light then
starts to flash. Then select the setting 0 and after about 5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
If the heating pad is no longer used after the timer expires:
• Switch off the heating pad (setting 0),
• Unplug from electrical outlet,
• Disconnect the controller from the heating pad.
6� Care, Maintenance and Disposal
Washing Instructions
DO NOT DRY CLEAN! DO NOT USE BLEACH! DO NOT USE WRINGER! DO NOT IRON YOUR HEATING
PAD!
If the heating pad is slightly soiled, use a dampen cloth and some mild detergent, if necessary. Use a dry,
lint-free cloth for controller cleaning and care.
WARNING
• Disconnect the mains plug. Do NOT pull by the cord.
• Do not reconnect the controller to the heating pad until the control connector and the heating
pad are completely dry. Otherwise there is a risk of electric shock.
• Never switch the heating pad on to help it dry. Otherwise there is a risk of electric shock
NOTICE
• Disengage pad/controller connectors.
• Never immerse the controller in water or other liquids. It may otherwise be damaged.
• Do NOT use chemical cleaning or scouring agents to clean the heating pad and controller. The
heating pad and controller may otherwise be damaged.
• Machine wash pad in warm water on gentle cycle; tumble dry on medium heat. Remove promptly
from the dryer. Or, hand wash in warm water and line dry.
• Do NOT plug in the heating pad until it is dry.
6