Important Safety Instructions; Safety Guidelines - VITO PRO-POWER POWERWASH 150 HQ Manual De Instrucciones

EN
aPPliCaTion
The portable pressure washing
machine is a highly specialized
multifunctional machine with
exceptionally reliable safety
assurance, which must be inspected
before it may be used to wash and
clean cars, bikes and other outdoor
equipment or garden patios, green
houses etc.
SafETy and warning
inforMaTion
auToMaTiC on/off:
The motor on this pressure washer
does not run continuously. It only
runs when the trigger of the spray
gun is squeezed. After following the
start up procedures in this manual,
turn the pressure washer ON and
squeeze the trigger for activation.
See "Operating Instruction" section
in this manual for further details.
warning:
The electric supply of this
machine should be protected by
a bifferential, which will interrupt
the supply if the leakage current to
earth exceeds 30 mA for 30 ms
or a device that will prove the earth
circuit.
warning: The machine is
intend to be used at a temperature
above S degree.
warning: The motor of this
pressure washer will NOT run
unless the trigger is squeezed.

SafETy guidElinES

This manual contains information
that is very important to know and
understand.
This information is provided
for SAFETY and to PREVENT
EQUIPMENT PROBLEMS.
iMPorTanT SafETy
inSTruCTionS
Save these instructions.
Read all instructions before using
the machine.
warning: When the machine is
used, following precautions should
always be considered:
To reduce the risk of injury, close
supervision is necessary when a
machine is used near children.
Always disconnect power before
disassembling or repairing the unit
of the machine.
Follow all safety codes as well as
the Occupational Safety and Health
Act (OSHA).
Ensure safety devices are operating
properly before using the machine.
DO NOT remove or modify any part
of the gun or unit of the machine.
Know how to stop this machine
and bleed pressure quickly.
Be thoroughly familiar with the
controls.
Stay alert – watch what you are
doing.
Do not operate the machine when
fatigued or under the influence of
alcohol or drugs.
Keep operation area clear of all
persons.
Do not overreach or stand on
unstable support. Keep good footing
and balance at all times.
Follow the maintenance instructions
specified in the manual.
Use cleaning agent supplied or
recommend by the manufacturer.
Only put the machine on stable
place when using, transportation,
assembly, dismantling. Do not
rough handling the machine when
transportation.
In any event of accident (e.g.
contact with detergents, rinse with
an abundance of clean water),
please always switch off the
machine and pull out the plug from
socket outlet, and Disconnect the
connection with water.
The machine is not intended to be
connected to the potable water
mains. If necessary, please use only
inlet hose-set approved by
IEC 61770. The necessary
length of the water supply hose
is 30 cm, and the pressure of the
water supply hose is 0.8 MPa.
Do not discharge streams at
persons or animal. This machine
is to be used only by trained
operators. Always remove lance
from gun before cleaning debris
from tip.
Keep clear of nozzle. Always wear
safety glasses or goggles and
protective clothing when operating
or performing maintenance.
Never put hand or fingers over the
spray tip while operating the unit.
Never try to stop or deflect leaks
with any body part.
Always engage the trigger safety
latch in the safe position even when
spraying is stopped for a moment.
Always follow detergent
manufacturer's label
recommendations for proper use of
detergents.
Always protect eyes, skin, and
respiratory system from detergent
use.
warning: Servicing of a
doubleinsulated machine.
In a double-insulated machine, two
systems of insulation are provided
instead of grounding.
No grounding means are
provided for a double-insulated
machine, nor should grounding
means be added to the machine.
Servicing a double-insulated
machine requires extreme care and
knowledge of the system, and
should be done only by qualified
service personnel.
Replacement pars for a
double-insulated machine must be
identical to the original parts.
19