Cleaning And Care - Klarstein 10028192 Manual De Instrucciones

Auto mode (only applicable to single-refrigeration model)
Select auto mode by pressing mode key or by means of remote control; and auto indicator lamp
is on. After selection of auto mode, the running states are determined in accordance with ambient
temperature: When the ambient temperature is over 25°C, the running state is the same as that in
refrigeration mode. While the ambient temperature is less than 25°C; the running state is the same
as that in air supply mode.
Timer mode
In standby state, pressing TIMER key can set timer startup. Press UP/DOWN key to set timer startup
time (0~24h), and timer indicator lamp is on. In startup state, pressing TIMER key can set timer
shutdown. Press UP/DOWN key to set timer shutdown time (0~24h), and timer indicator lamp is on.
Drainage method
If water container inside the machine is full of water, the display
screen will flash show "FL" with sound alarm, compressor stops ope-
ration automatically. At the moment water should be drained, and
the specific steps are as follows:
1. Disconnect power line plug, and remove exhaust pipe assembly.
2. Move the air conditioner to an appropriate location.
3. Pull out water plug at water outlet to drain all the water inside
the machine.
4. Stuff up water plug again.
5. Re-install exhaust pipe assembly, and start the machine.
Maintenance
Attention: To prevent electric shock, please turn of the air conditioner and disconnect plug before
maintenance or repair. Scrub with soft semi-dry cleaning cloth. Do not use chemical reagents, such
as benzene, alcohol and gasoline, etc., otherwise, the surface of the air conditioner, and even the
whole machine will be damaged. Do not splash water into the air conditioner.
Strainer
Cleaning of strainer once per two weeks is re-
commended, and the cleaning frequency should
be properly increased if indoor air quality is bad.
Jamming of strainer by dust will reduce efficacy of
the air conditioner. The specific cleaning steps are
as follows:
1. As per the direction shown in figure below,
first remove air-inlet grille, and then remove
strainer.
2. Put strainer into fresh water or warm water
(approximate 40°C) added with neutral deter-
gent to clean up, and then keep it in cool place
to dry.
3. Re-install the cleaned and dried strainer.
4. Restart the machine into normal operation.
13

Cleaning and Care