Kohler K-705700 Guia De Instalacion página 12

Inside of Shower
7. Assemble and Attach the Hinge Jamb
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass directly on the floor.
NOTE: Make sure you choose the correct hinge bracket. The weld nut groove should point towards the
near edge of the glass.
Slide two weld nuts into the groove of the lower hinge bracket and space them so that they align
with the holes in the door panel.
Insert a bushing onto each weld nut.
NOTE: There is a label on the door panel identifying the "non-coated side" of the panel. The bracket
should be located on the non-coated side of the door panel.
Position the bracket on the door panel so that the weld nuts pass through the two holes in the door
panel.
Position the back plate on the opposite side of the door panel, so that it hooks into the bottom of
the bracket.
Insert a screw into each of the two weld nuts through the slot in the back plate and tighten firmly.
Do not overtighten.
Repeat this procedure to install the top hinge bracket on the door panel.
1064866-2-B
Screw
Screw
Glass Door Panel
Back Plate
12
Lower Hinge Bracket
(groove aligns with
edge of glass panel)
Weld Nut
Bushing
Kohler Co.