Kohler K-705700 Guia De Instalacion página 16

11. Adjust and Secure the Door
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass directly on the floor.
CAUTION: Do not allow the edges of the glass panel to contact the bottom track, or the seals. Contact
may shatter the glass or tear the seals.
Install the handles following the instructions packed with them.
Align the door with the strike lite glass panel.
IMPORTANT! Only loosen the screws enough for the door panel to move. If the screws are loosened too
much the weight of the door may pull the hinge and back plate apart. (If the hinge and back plate pull
apart, lift the door to remove stress and re-tighten the screws.)
If the door needs adjusting, loosen the screws located in the hinges (do not remove) one bracket at a
time and adjust the panel as needed.
When the door is properly aligned the bottom edge of the glass should be parallel with the bottom
track.
When the door is properly aligned, fully tighten the screws. Do not overtighten.
1064866-2-B
5/32"
Hex Key
Hinge
Screws
16 Kohler Co.