DOMUS LINE APEX TWA Manual De Instalación página 6

INSTALLATION MANUAL
WARNING:
Safety is guaranteed if these instructions are followed and therefore
they must be kept. Installation may require the involvement of
qualified personnel. Before proceeding with installation of the device
ensure that the environmental conditions are in compliance with and
suitable for the product characteristics. Before any operation on the
device disconnect mains power.
INSTALLATION:
- The pictures 1 and 2 represent some examples of installation of
APEX TWA. The quotas are indicative because they can change
according to the application and to the material from which the plan
of installation is composed. The two examples differentiate
themselves for the position of the exit hole of the cable, nevertheless
it is possible make this hole also in other positions according to the
demand of the customer and to the type of application.
For installations with the power cord in radial position to drill a hole on
the ø ≥ 8mm mounting plan as shown in the example in Figure 1. In
terms of specific requirements, it is possible to drill the power cable
outlet hole in other positions, provided they do not affect the integrity
of the cable and/or connector installed on it.
- Feed the power cable into the hole and install the lighting profile by
applying light pressure until it is seated in the recess, as shown in
figure 3.
CONNECTING THE DEVICE TO THE POWER SUPPLY _ Tunable White
dynamic light configuration D-MOTION
- Connect the APEX TWA power supply cable to one of the light colour
dynamic adjustment systems D-MOTION sold separately and with
power at least 10% greater than the total load. For the total load
calculation check plate data printed on the product label.
EN
- For installation and operation of the light colour dynamic adjustment
system see the specific item's manual.
- Then connect the light colour dynamic adjustment system to a safe
power supply with 24Vdc stabilised voltage (sold separately) and with
power at least 10% higher than the total load. For the total load
calculation check plate data printed on the product label.
- If more than one device must be connected to the power supply unit
ensure that the total sum of the power absorbed by the devices (check
the plate data shown on the product label) does not exceed the
maximum power permitted both by the dynamic adjustment system
and by the Converter.
WARNING:
The Led MODULE, the power supply cable or any switch used, are not
replaceable, therefore in case of damage the device must be entirely
substituted.
WARRANTY
DOMUS Line guarantees the product only if powered with a Converter
supplied by us.
The warranty's general terms and conditions for this device are
available at www.domusline.com
CAUTION
ONLY SUITABLE FOR DRY LOCATION
CABINET USE ONLY
USE ONLY 24Vdc CLASS 2 POWER SUPPPLY
TYPE IC RECESSED – INHERENTLY PROTECTED
TO REDUCE THE RISK OF FIRE DO NOT INSTALL CLOSER THAN 10mm TO
THE CABINET WALL OR IN A COMPARTMENT SMALLER THAN 300mm BY
300mm