Transmitter Lights & Buttons; Led Light - Tena SmartCare Instrucciones De Uso

Battery installation
Once the battery has been installed in the
transmitter:

LED LIGHT

WHAT IT MEANS
Blinks five times:
The battery is in the correct
position. Attach the transmitter
to the sensor strip.
No light: OK
The light disappears after a few
seconds. Check for power by
pressing both buttons simulta-
neously for two seconds.
Applying the Change Indicator to the incontinence product
Press both buttons simultaneously for two seconds at every change to register the
change in the system.
LED LIGHT WHAT IT MEANS
Steady light for a few seconds:
Everything is OK.
Blinks five times:
The transmitter is not attached
properly or the battery is low. Try
re-attaching the transmitter. If it
does not help, change the battery.
No light:
Error. See pp. 26–30 for more
information.
TRANSMITTER LIGHTS & BUTTONS
TRANSMITTER LIGHTS & BUTTONS
Buttons
LED light
Change Indicator assembly
Once the transmitter has been attached to
the sensor strip:
LED LIGHT
25
TENA SmartCare Change Indicator
NOTE
The LED light can be difficult
to see if exposed to a strong
sunlight, for example. Try to
block the sunlight to improve
readability.
WHAT IT MEANS
Steady light for a few seconds:
Everything is OK.
Blinks five times:
The transmitter is not attached
properly or the battery is low.
Try re-attaching the transmitter.
If it does not help, change the
battery.
No light: OK
The light disappears after a few
seconds. Check for power by
pressing both buttons simulta-
neously for two seconds.
TM/MC
EN