Publicidad
Step 6
Carefully turn your unit over onto its front edges.
å
Fasten the END MOLDINGS (I) to the ENDS (A and B).
å
Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: There are no pre-drilled holes in the END
å
MOLDINGS. The SCREWS will tighten into the grooves.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Groove to inside
Page 10
1S
A
411371
M22
I
Groove to inside
Just think. The sooner
you do this, the sooner
you do something else.
The END MOLDINGS (I)
should be against the
TOP MOLDING (M22).
B
I
www.sauder.com/service
Publicidad
