Setting Up For Operation; Straight Cutting; 0 - 45° Cutting; Adjusting The Blade - Freeman P13INLC Manual Del Usuario

SETTING UP FOR OPERATION

1. The laminate flooring cutter is shipped with the
blade assembly in the down and locked position.
This safety feature ensures that the cutting edge of
the blade is not exposed during transport or
storage. To unlock the blade assembly, loosen the
safety lock knob (Fig. 3-A), depress the handle
then slide the lock knob to the right to disengage
the lock (Fig. 3-B).
A
B
FIGURE 3
08
HTTP://WWW.FREEMANTOOLS.COM
MODEL: P13INLC
WARNING:
Do not put your fingers against the sharp
edge of the blade at any time.

STRAIGHT CUTTING

1. Adjust the angle gauge (Fig. 4 - A) so the red arrow
is pointing at the 0º mark, and tighten the knob
(Fig. 4 - B).
2. Insert material between the cutting blade and the
base, flush with the angle gauge. Push the handle
down to complete a cut.
C
B
A
FIGURE 4
1-888-669-5672
MODEL: P13INLC
WARNING:
Maintain control of the handle. Do not
allow handle to slam back after making
cut.
0 - 45° CUTTING
1. Adjust the angle attachment to 45º and tighten the
knob. Insert material between the cutting blade and
the base, flush with the angle attachment (Fig. 5).
Push the handle down to complete a cut.
FIGURE 5
HTTP://WWW.FREEMANTOOLS.COM

ADJUSTING THE BLADE

1. Unscrew and remove the adjustment plate screws
(Fig. 6).
FIGURE 6
1-888-669-5672
09