Beko WMD 57122 Manual Del Usuario página 3

2 Installation
Removing packaging reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation locks
A
Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will be
damaged!
1. Loosen all the bolts with a spanner until
they rotate freely ("C")
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with
the Operation Manual) into the holes on
the rear panel. ("P")
C
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in the
future.
C
Never move the appliance without the
transportation safety bolts properly fixed
in place!
Adjusting the feet
A
Do not use any tools to loosen the lock
nuts. Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts
on the feet.
2. Adjust them until the machine stands level
and firmly.
3. Important: Tighten all lock nuts up again.
Connecting to the water supply.
Important:
• The water supply pressure required to run
the machine must be 1-10 bar (0,1 – 1
MPa).
• Connect the special hoses supplied with
the machine to the water intake valves on
the machine.
• In order to prevent water leakage that
may occur at the connection points, there
are rubber seals (4 seals for the models
with double water inlet and 2 seals for
other models) attached to the hoses.
These seals should be used at the tap
and machine connection ends of the
hoses. The plain end of the hose fitted
with a filter must be attached to the tap
and the elbowed end must be attached
to the machine. Tighten the nuts of the
hose well by hand; never use wrenches to
tighten the nuts.
• Models with a single water inlet should
not be connected to the hot water tap.
When returning the appliance to its place after
maintenance or cleaning, care should be taken
not to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to the
edge of a washbasin or bathtub. The drain hose
should be firmly fitted into the drain as to not get
out of its housing.
Important:
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
• The hose should be attached to a height
of at least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying it
on the floor level or close to the ground
(less than 40 cm above the ground),
water discharge becomes more difficult
and the laundry may come out wet.
• The hose should be pushed into the
drainage for more than 15 cm. If it is too
long you may have it shortened.
• The maximum length of the combined
hoses must not be longer than 3.2 m.
3 - EN