Maintenance And Cleaning; After-Sales Service And Application Service - Bosch Truvo Manual Original

OBJ_BUCH-2841-002.book Page 26 Thursday, August 4, 2016 6:22 PM
26 | English
Cause
Measurement results inaccurate/implausible
Interfering metal ob-
jects in the area of the
sensor
Auto calibration not
successful
Continuous flashing green/yellow/red,
even when no metal or "live" cable is in the vicinity.
Measuring tool is
defective.
* Therefore, please also observe other information sources (e.g. construction plans)
before drilling, sawing or routing into walls, ceilings or floors.

Maintenance and Cleaning

Wipe away debris or contamination with a dry, soft cloth. Do not use
cleaning agents or solvents.
In order not to affect the measuring function, decals/stickers or name
plates, especially metal ones, may not be attached in the sensor area 7 on
the front or back side of the measuring tool.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning mainte-
nance and repair of your product as well as spare parts. Exploded views
and information on spare parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning
our products and their accessories.
In all correspondence and spare parts orders, please always include the
10-digit article number given on the nameplate of the product.
1 609 92A 3FC | (4.8.16)
Corrective Measure
Remove all interfering metal objects (e.g. watches,
bracelets, rings, etc.) from within range of the
sensor. Do not hold the measuring tool close to
the sensor.
Perform a manual calibration.
Send the measuring tool in for service.
Bosch Power Tools