Maintenance And Service - Bosch Wallscanner D-tect 150 Instrucciones De Funcionamiento Y Seguridad

Dtect150_1609929X08_3-15.qxp_D-tect150 3/20/15 10:53 AM Page 15
Magnetic Object (see figure D)
A magnetic object (e.g. a steel bar) is within the
sensor range. Further objects are also located to the
left and right, outside of the sensor range.
The object depth is 8.8 cm. The detection tool emits
an audio signal.
Copper Pipe (see figure E)
A metal object (e.g. a copper pipe) is within the
sensor range. The object depth is 4 cm. The
detection tool emits an audio signal.
Plastic or Wooden Object
(see figure F)
A non-metal object is within the sensor range. The
object is plastic or wooden, and close to the surface.
The detection tool emits an audio signal.
Maintenance and Cleaning
• Check the measuring tool each time before
use. In case of visible damage or loose
components inside the detection tool, safe
function can no longer be ensured.
Keep the detection tool clean and dry at all times
to ensure proper and safe working conditions.
Do not immerse the detection tool in water or other
fluids.
Wipe away debris or contamination with a dry, soft
cloth. Do not use cleaning agents or solvents.
Pay attention that the maintenance
cover 7 is always properly closed. The
maintenance cover may only be
opened by an authorized service center
for Bosch power tools.
Detection tool, batteries, accessories and packaging should be sorted for
Large Surface
(see figure G)
A metal, large surface (e.g. a metal plate) is within
the sensor range. The object depth is 2 cm. The
detection tool emits an audio signal.
Many Unclear Signals
(see figures H–I)
When many objects are shown in the standard start
display, the wall probably consists of many hollow
spaces. To broadly block out the hollow spaces,
switch to the "Metal" operating mode.
When there are still too many objects being shown,
carry out several height-offset measurements and
mark the detected objects on the wall.
Offset marks are an indication for hollow spaces,
whereas marks on a line indicate an object.

Maintenance and Service

If the detection tool should fail despite the care
taken in manufacturing and testing procedures,
repair should be carried out by an authorized
service center for Bosch power tools. Do not open
the detection tool yourself.
In all correspondence and spare parts orders,
please always include the 10-digit article number
given on the type plate of the detection tool.
Store and transport the detection tool only in the
supplied protective pouch.
In case of repairs, send in the detection tool
packed in its protective pouch 18.
DISPOSAL
environmental-friendly recycling.
-15-