How To Assemble Your Ceiling Fan - Fanimation LEVON FP7910 Serie Manual De Instrucciones

How to Assemble Your Ceiling Fan

1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, blue, white wires and safety cable through the
downrod. (Figure 3)
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip.Tighten the two set screws
and locking nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Downrod
Set Screw
Hairpin Clip
Downrod
Downrod Support
Set Screws
and Locking
Nuts (2)
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, Blue, White wires
and Safety Cable
Set Screws
and nuts (2)
Figure 3
Downrod
Clevis Pin
Hairpin Clip
Figure 4