Safety Rules For Laser Lights - GMC DB250SMS Manual De Instrucciones

• When cutting long pieces which extend well over the table width,
ensure that the ends are adequately supported at the same height
as the saw table top. Supports should be positioned in such a way to
ensure that the workpiece does not fall to the ground once the cut has
been made. A number of supports at regular intervals may be required if
the workpiece is sufficiently large
• Only use saw blades for cutting material they were designed to cut.
Using an incorrect blade can damage the power tool and cause injury to
the user
• The tool must be used only for its prescribed purpose. Any use other
than those mentioned in this manual will be considered a case of
misuse. The user, and not the manufacturer, shall be liable for any
damage or injury resulting from such cases of misuse
• The manufacturer shall not be liable for any modifications made to the
tool nor for any damage resulting from such modifications
• Even when the tool is used as prescribed it is not possible to eliminate
all residual risk factors

Safety rules for laser lights

The laser used in this device is a Class 2 laser with maximum power of
≤1mW and a wavelength of 400-700nm.
These lasers do not normally present an optical hazard, although staring at
the beam may cause flash blindness.
WARNING: Avoid direct eye contact.
A hazard may exist if you deliberately stare into the beam, please observe
all safety rules as follows:
• The laser shall be used and maintained in accordance with the
manufacturer's instructions
• Do not switch on the laser light until the tool is ready to cut
• Never aim the beam at any person, and particularly not into the eyes of
any person or animal, or any object other than the workpiece
• Always ensure the laser beam is aimed at a sturdy workpiece without
reflective surfaces. i.e. wood or rough-coated surfaces are acceptable.
Reflective sheet steel or similar is not suitable for laser use as the
reflective surface could direct the beam back at the operator
• Do not change the laser light assembly. Repairs must only be carried
out by the laser manufacturer or an authorised agent. Do NOT
exchange with a different type of laser
CAUTION: Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Please refer to the relevant EN standards, EN60825-1/A1:2002 for
more information on Lasers.
9
Product Wave Length: 650nm,
Output Power: ≤1mW
EN 60825-1:1994+A2:2001+A1:2002
GB