Tabla de contenido
Publicidad
WARNING
Disconnect the cable from the power outlet before carrying out any adjustment,
service or maintenance to the tool.
Cleaning and Care
• Keep the tool dust-free. Never use water or chemical
substances to clean the tool. Use only a clean and dry
cloth.
• Always keep the ventilation slots clean and free of
obstructions to guarantee the adequate cooling of the
motor.
• Inspect regularly all the mounting screws. Make sure that
are tightly fastened. If a screw is loose, tighten immediately.
• The armature and motor are the power tool's heart. Use
extreme care not to affect the tool with oil or water.
• In a regular basis, double-check the power cable. Look
for any type of damage. If the cable is damaged take it to a
Authorized Service Center.
10
ENGLISH
Maintenance
Service
Servicing the tool shall only be carried out in a
Authorized Service Center.
Service and maintenance carried out by non-qualified
people may be dangerous and may cause personal
injuries. It also makes the Warranty void.
Carbon Brush Replacement
• Carbon Brushes should be periodically checked and
when worn, replaced always in a
Authorized Service Center.
• After replacing the carbon brushes request to inspect if
the new carbon brushes can move freely in the carbon
housing. Also request to run the tool 5 minutes to make
even the contact with the carbon brushes and the
commuter.
• Use only original
brushes specifically designed with the hardness and
resistance adequate for each type of motor. Carbons
that are out of specification could damage the motor.
• When replacing carbon brushes, always replace both.
Notas
spare carbon
Publicidad
Tabla de contenido
