Instructions Of Use - Jata electro EV107 Instrucciones De Uso

• Keep all plastic bags and packaging components out of the
reach of children. They are potentially dangerous.
• Do not connect to the mains without checking that the voltage
on the rating plate and that of your household are the same.
• Do not leave unattended while in use.
• Take care the cable does not touch any hot parts.
• Don't allow children play with the appliance. Keep the
appliance out of the reach of children.
• Keep out of curtains or other flammable materials.
• Avoid any contact with the sealing strip. It is hot and can burn.
• Keep away from hot surfaces.
• This appliance has been designed for domestic use only.
• VERY IMPORTANT: Do not immerse the appliance in
water or any other liquid.
• To unplug, pull from the plug, never from the cable.
• It must not be used outdoors.
• The cleaning and maintenance done by users, cannot be done
by children without any supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.

INSTRUCTIONS OF USE

• Always use original spare parts available in www.jata.es
I. Making a bag with a plastic roll
1. Adjust the support for the rolls to the desired wide and place the roll. Connect the appliance to the mains.
2. Lift up the blade guide (15) and insert the start of the roll by under.
3. Stretch the roll until the desired measurement for the bag is obtained.
4. Slide the blade (16) pressing down on the blade guide (15).
5. Place the end of the cut piece on the sealing strip.
6. Close the top cover and press tightly until you hear a "click" on both sides.
7. Presses the "solo sellado -only sealing" button to start sealing the bag. Once the light is switched off, the
process will be finished.
8. Press the open buttons to open the cover and remove the bag. The bag will then be ready for vacuuming
and sealing.
II. Vacuum packaging with bag
1. Place the items inside the bag. Use only the special bags with vacuum channels.
2. Clean and stretch the opening of the bag, ensure that there is no dust, waves or wrinkles and have in mind
that the sealing area is totally dry.
3. Place the opening of the bag inside the vacuum chamber (10). Ensure that the air intake is not covered by
the bag.
12