KTM 62112935044 Manual Del Usario página 8

2
8
1
2
A B
Fastening the reed switch (all models)
- Position the reed switch (1) on the rear frame against the seat lock as shown
and bond centrally onto the rack.
- Connect the reed switch to the wiring harness.
NOTE:
In addition, the reed switch can be screwed into place with the oval head
tapping screws
DIN7981- 3.5X10. To do this, mark the drill holes and
pre-drill using a D3 mm drill.
- Drill open the marked holes with a D3 mm drill.
Caution: Do not drill all the way through!
- Bond the magnet (2) , making sure that the holes are perfectly aligned.
- Secure with oval head tapping screws DIN7981- 3.5X10.
(A) SM/SM-R seat
(B) SM-T seat
NOTE:
It may be necessary to make minor adjustments to the seat bottom.
Final steps
- Stow the tool set in the storage compartment with the rubber strap.
- Mount the seat.