Troubleshooting - Battipav VIP Manual De Instrucciones

Battipav srl
DISPOSAL
When parts wear out or when the machine is fi nally
scrapped, waste disposal must be carried out in
compliance with the laws in force.
Electric Motor
Aluminium
Steel
Copper
Polyamide
Main Body
Steel
Polyamide

TROUBLESHOOTING

HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON
This electric tool complies with the relevant safety rules. Repairs should only be carried out by qualifi ed
persons using original spare parts, otherwise this may result in considerable danger to the user.
Faul
The machine does not work.
If lubrication does not arrive at the
disk with the pump running.
Motor gives off unpleasant odour.
Machine is diffi cult to start.
The machine is cutting out of square.
Polyamide
Steel
Aluminium
Copper
Epoxy Resin
W.E.E.E. IT08020000002803
The
AL
arranges that in the event of scrapping
AC
of electrical equipment, they must not
CU
be disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
PA
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2002/96/CE, all
AC
electrical equipments must be marked with crossed
PA
basket symbol.
The packing of the machine will be disposed of in
accordance with the methods laid down by current
legislation.
For
of electrical equipment, please refer to public
administration service.
Cause
The power supply cable is damaged or
not properly connected.
No voltage in the socket.
Control switch is damaged.
The sprayer unit is clogged.
Water may have seeped through inside
the motor
Motor bearings are damaged.
The tile supports are not at right angles
with the cutting disc.
The disc is not suitable for the type of
material to be cut.
Submersed pump
European Directive
further information
Remedy
Press the plug fi rmly into the power
socket. Check the power supply cable.
Have the socket checked.
Consult local dealer for replacement.
Dismantle the sprayer assembled inside
the disk cover and remove any possible
residuals.
Unplug the power supply cable and
consult local dealer.
Unplug the power supply cable and
consult local dealer.
Using a square, adjust the tile supports
to 90° in relation to the cutting line of
the disc.
Replace the disc with a more suitable
one.
GB
PA
AC
AL
CU
2002/96/CE
concerning disposal
23