Assembly; Installing The Receiver - Home Decorators Collection 26666 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
6
Setting the remote control codes
NOTE: The frequencies on your receiver and remote control have
been preset at the factory. Before installing the receiver, make
sure the dip switches on the receiver and remote control are set
to the same frequency. The dip switches on the remote control
are located inside the battery compartment.
NOTE: This remote is equipped with a 16-code combination.
To prevent possible interference from or to other remote units,
such as garage door openers, car alarms, or security systems,
change the combination code, but be sure that the code on both
the hand held transmitter and receiver in the fan are the same.
To set the code on the remote control:
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
To set the code on the receiver:
□
Slide the code switches to the same position as set on your
remote control.
□
Replace the battery cover on the remote control.
Controller Model: FAN28R-240W
ON
1 2 3 4
ON
1 2 3 4
7

Installing the receiver

WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements. The
electrical source and fan must be 115/120 volt, 60Hz.
CAUTION: If other fan wires are a different color, have this unit
installed by a licensed electrician.
□
Position the supply wires to the left side of the mounting
bracket (A); position the fan wires to the right side. Partially
insert the remote control receiver (H) (flat side up) until one
end rests on the ball/downrod assembly (B).
9
Please contact 1-800-986-3460 for further assistance.
H
A
C
B
HOMEDEPOT.COM/HOMEDECORATORS