Dyna-Glo DGPH901ATBR Instrucciones De Ensamblaje página 4

ASSEMBLY INSTRUCTIONS
Note: If this is a new unit, please see the
instruction manual included with the patio
heater to begin assembly.
If you are placing this on an already
assembled unit:
2. a. Make sure the control knob is in the OFF
position and the patio heater has cooled.
b. Lift up the cylinder housing.
c. Close the cylinder valve by turning clockwise.
Disassemble the regulator and the cylinder
valve.
d. Remove the propane cylinder from the base.
3. Unscrew the four stainless steel M6x10mm bolts
connecting the post and the reflector / head
assembly and put them aside for later use.
Remove the complete reflector and head
assembly from the post. Be careful that the
regulator does not hook onto the post when
taken out. Put the reflector and head assembly
aside.
2
Control Knob
Cylinder Housing
Cylinder Valve
Regulator and
Hose Assembly
Base
3
Reflector &
Head Assembly
Stainless Steel
M6x10mm Bolts
Post
4