Dyna-Glo DGPH901ATBR Instrucciones De Ensamblaje página 8

ASSEMBLY INSTRUCTIONS
10. To change or access the propane tank, you will need to
completely unscrew the nut and move the table and
nut all the way up to the top of the post. Lightly tighten.
Use the assistance of a second person to hold up the
cylinder housing while you tend to the propane tank.
For Patio Heater Operation instructions, please refer back to the instruction manual that came with the unit.
CONNECTING GAS CYLINDER
Use only 20-pound cylinders (approximately 18 ¼ inches high and 12 ¼ inches in diameter) equipped with a
cylinder connection device compatible with the connection for outdoor cooking appliances. The gas cylinder
should not be dropped or handled roughly!
Minimum Gas Supply Pressure : 5.0 psi / 35 kPa
Maximum Gas Supply Pressure Bottle pressure
Outlet prssure setting of regulator is 11.0 in. W.C / 2.74 kPa -LPG.
Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outoors in a well-ventilated area out of the reach of children. A disconnected
cylinder must have dust caps tightly installed and must not be stored in a building, garage or any other enclosed
area. The minimum hourly of 17000Btu/H / 4.98 KW is required input rating for a heater for automatic operation
at ratings less than full input rating. The pressure regulator and hose assembly supplied with the appliance must
be used. The installation must conform with local codes, or in the absence of local codes, with national fuel gas
code, ANS Z223.1/NFPA54, natural gas and propane Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
10
Table
Cylinder Housing
Cylinder Valve
Regulator and
Hose Assembly
Base
8