Operation - Klarstein 10032776 Manual Del Usuario

EN
16

OPERATION

<Work/Standby: Plug in the power,the buzzer will "beep" for along time,press the
standby key (On/Standby) to enter the high-grade heating working state,and then
press the standby key to enter the standby state.
Gear selection: For work status, press "MODE" key to select one of work modes
such as high gear, medium gear, low gear and energy saving gear.
Temperature setting: Under the working status,press and hold the
to set the temperature,press and hold these keys to quickly set the temperature;after
setting the temperature,have non-operation for 5 seconds,exit the temperature setting
screen.After the initialuse or memory clear,the whole machine runs according to the
factory settings.
The default setting temperature is 35° C and the gear position is high-end.
Scheduled work: Tap the timer key
work setting screen. Press the
key or key for along time to quickly set the scheduled time,and the scheduled time will
reach the working status of the machine.The buzzer will ring with along beep.
Scheduling standby: Under the working status,press the timer key
scheduling standby setting screen.Press" "key or" "key to set the scheduling
time,press" "key or" "key for along time to quickly set the scheduling time,and the
scheduling time is in the standby state to the machine.
A:the scope of scheduling is for 0~24hours,and press" "key or" "key each time to
increase or decrease 1 hour.When the set value is 0H,press the" "key to set the
time for 24H.When the set value is 24H,press the" "key,and the setting time is
0H.When the set value is 0H,the scheduling is canceled. When the set value is not
0H,the scheduling is started.Set the appointment time,press the timing key" "key or
"MODE"key,or without operation for 5 seconds,exit scheduling mode.
If the scheduling time is set,press the standby key
cancel the scheduling.
Cancel timer: B:If the scheduling time isset,press the standby key
state and cancel the scheduling.
After the scheduling is started,press the scheduling key
the appointment and reset the scheduling time.During the scheduled time,the machine
is shut down or started upunder temperature control,and the scheduled time is always
normal,and free from down time.During the scheduled time,it is cleared incase of power
failure.
in standby mode to enter the scheduled
key or keyy to set the scheduled time, press the
to enter the standby state and
to check the remaining time of
key or key
, to enter the
to enter the standby