Switching On And Off - STERWINS 1200 BC-2 Manual De Instrucciones

2. SAFETY INSTRUCTIONS
3
0
with active or passive medical implants! To reduce the risk of serious or
fatal injury, we recommend persons with medical implants to consult
their doctor and the medical implant manufacturer before operating
this product!
Trimming
Before use, check that the cutter in good working order and that the
length of the blade is correct, as follows:
1. Ensure the switch is on the off position and disconnect the cable plug
from the mains supply.
2. Examine the general condition of the tool. Inspect the guard, switch,
and blade. Check for loose screws, misalignment, and binding of moving
parts, improper mounting, broken parts and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs
during operation, turn the machine off immediately and have the
problem corrected .Do not use a damaged tool and attach a label "DO
NOT USE" to the tool.
3. Ensure that you are on a flat surface and have secure footing.

SWITCHING ON AND OFF

Connect the cable to the power.
To switch on, pull the safety lock-off button forward and then keep the
switch trigger depressed.
To switch off, release the switch trigger.
WARNING! The tool runs for approximately 5 seconds after it has been
switched off. Let the motor came to a complete stand still before setting
the tool down.
EN
This product produces an electromagnetic field during
operation! This field may under some circumstances interfere
276