Troubleshooting - STERWINS ETHT2-50.3 Manual De Instrucciones

Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most
cases the problem can be solved quickly.
Problems
Not connected to power supply
Product does not
Power cord or plug is defective
start
Other electrical defect to the
product
Extension cord not suitable for
operation with this product
Product does not
Power source (e.g. generator)
reach full power
has too low voltage
Air vents are blocked
Blade is worn/damaged
Unsatisfactory
cutting
performance
Thickness of branches exceeds
capacity
Blade is damaged
Excessive
vibration/noise
Bolts/nuts are loosen
Possible cause
225

5.TROUBLESHOOTING

Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Have it replaced with new one,and need
to sent it to after sales service agent for
replacing.
Only cut branches complying with the
capacity
Have it replaced with new one,and need
to sent it to after sales service agent for
replacing.
Tighten bolts/nuts
EN